Option Actions
b Press the Volume Up or Volume Down
button to toggle Bluetooth Off.
Turning the Bluetooth Off through the Voice
Assistant
a Press the Voice Assistant
button.
b After you hear a tone, speak your com-
mand into the accessory microphone.
If the Bluetooth is turned off, the voice announcement sounds.
12.1.2
Bluetooth Pairing
Bluetooth pairing happens automatically when you:
•
Turn on your device.
• Turn on the Bluetooth feature.
If your device is searching for other Bluetooth device, your device shows the following indications:
• The voice announcement sounds.
• The top and bottom crescent aqua LED blinks.
If the Bluetooth device is connected to your device, your device shows the following indications:
• The top and bottom crescent aqua LED illuminates for 2 seconds.
• A delayed voice announcement sounds.
NOTE: If both wired earpiece and Bluetooth earpiece are connected to the device at the same
time, the wired earpiece overrides the audio output.
12.1.3
Bluetooth Connection Failure
When the Bluetooth accessory is out of the Bluetooth connection range or removed, the device is
disconnected and experience signal interference.
Your device shows the following indication while reconnecting to the same Bluetooth accessory within
an allocated time:
•
A tone sounds.
• The top and bottom aqua crescent LED blinks twice.
After timeout, your device starts searching for a wired earpiece.
If your device is not connected to a wired earpiece and you are not charging your device, the device
shows the following indications:
• The device vibrates.
• The top and bottom red crescent LED blinks alternately with the purple crescent LED.
12.1.4
Checking Bluetooth Status
Procedure:
1 Press the Voice Assistant button.
MN009911A01-AA
Chapter
12 : Connectivity
41