CHAPTER 3 AWARD
®
BIOS SETUP
3-17
3.7 Integrated Peripherals
Onchip IDE Channel0 Enabled
Onchip IDE Channel1 Enabled
IDE Prefetch Mode Enabled
Primary Master PIO Auto
Primary Slave PIO Auto
Secondary Master PIO Auto
Secondary Slave PIO Auto
Primary Master UDMA Auto
Primary Slave UDMA Auto
Secondary Master UDMA Auto
Secondary Slave UDMA Auto
Init Display First PCI Slot
IDE HDD Block Mode Enabled
Onboard FDD Controller Enabled
Onboard Serial Port 1 Auto
Onboard Serial Port 2 Auto
UART 2 Mode Standard
X IR Function Duplex Half
X TX,RX inverting enable No, Yes
Onboard Parallel Port 378/IRQ7
Onboard Parallel Mode Normal
ECP Mode Use DMA 3
Parallel Port EEP Type EEP 1.9
Onboard Legacy Audio Enabled
Sound Blaster Disabled
SB I/O Base Address 220H
SB IRQ Select IRQ 5
SB DMA Select DMA1
MPU-401 Disabled
MPU-4-1 I/O Address 330-333H
Game Port (200-207H) Enabled
Item Help
Menu Level >
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-safe defaults F7:Optimized Defaults
CMOS Setup Utility - Copyright(C) 1984-2000 Award Software
Integrated Peripherals
OnChip IDE Channel0/Onchip IDE Channel1
The integrated peripheral controller contains an IDE interface
with support for two IDE channels. Select Enabled to activate each
channel separately. The settings are: Enabled and Disabled.
IDE Prefetch Mode
This item is used to Enabled or Disabled the IDE Read/Write
Prefetch buffer. This buffer is used to store data for faster perform-
ances.
To Next Page
Loading...
Need help?
General
