CHAPTER 3 AWARD
®
BIOS SETUP
3-29
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup if you
have installed a new add-on and the system reconfiguration has caused such
a serious conflict that the operating system can not boot.
The settings are: Enabled and Disabled .
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically
configure all of the boot and Plug and Play compatible devices. However,
this capability means absolutely nothing unless you are using a Plug and
Play operating system such as Windows
95/98. If you set this field to
“manual” choose specific resources by going into each of the sub menu that
follows this field (a sub menu is preceded by a “Ø”). The settings are:
Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system inter-
rupt a type, depending on the type of device using the interrupt.
DMA Resources
This sub menu can let you control the DMA resource.
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
Assign IRQ for VGA
Leave this field at Enabled. The settings are Enabled, Disabled.
Assign IRQ for USB
Leave this field at Enabled. The settings are Enabled, Disabled.
To Next Page
Loading...
Need help?
General
