Hardware Setup
2-23
PS2 KB/MS Wake-Up Jumper: J4
The J4 jumper is used to set PS2 keyboard/mouse wake-up feature. To use this
function, you should also go to BIOS to enable the keyboard and mouse wake-
up function.
Note: To be able to use this function, you need a power supply that provides
enough power for this feature. (Power supply with 750mA 5V Stand-by)
1
3
Disable
1
3
Enable
IDE RAID Enable/Disable Jumper: J3
For onboard IDE RAID connectors, you can use this jumper to enable or
disable the IDE RAID controller.
1
3
Enable
1
3
Disable
J3
J4
To Next Page
Loading...
Need help?
General
