mycom 2016LMC User Manual

2200LZJE-HO-C6-N_2013.12.
Chapter 1 Safety
Compound 2-stage Screw Compressor 2016**C 1.4 Safety Devices
1-6
1.4 Safety Devices
For safe use and protection of this product, make sure to attach safety devices to this product in
accordance with the regulations and the following instructions.
Safety devices cannot be kept in normal condition unless inspected and maintained at regular intervals.
Their maintenance and inspection need to be performed as an important part of the
maintenance/inspection work project. Provide users of this product with necessary information on the
safety devices, for example, types of the safety devices, installation position, function, and inspection
method of safety related devices.
 Check the safety devices after turning on the power and before operation of the
compressor. If they do not operate normally, immediately take repair or replace
safeties before starting compressor.
1.4.1 Emergency Stop Button
 Overview/Function/Purpose
The emergency stop buttons are used to stop the compressor operation immediately if an
emergency occurs in this product.
 Installation Positions
On the control board and in the operation control room
 Stop/Restoration Methods
For information on how to stop or restore the emergency stop button, refer to the instruction manual
of the unit.
 Inspection Method/Cycle
The emergency stop buttons must be tested before commissioning and must also be periodically
re-tested after that. For the inspection method and frequency for the emergency stop button, refer
to the instruction manual of the unit.
1.4.2 Breakers of Motor Main Power and Control Power
(with Lockout/Tagout Mechanism)
 Overview/Function/Purpose
Turn off the main motor and control power, and if there is any possibility of danger during work
(especially during cleaning, maintenance, inspection, or troubleshooting), lockout/tagout devices
must be used on the breakers of the main motor and control powers to prevent injuries to workers in
case the power is turned on accidentally during work.
 Methods of Performing and Releasing Lockout/Tagout
Make sure to clearly notify methods of performing and releasing lockout/tagout referring to the
regulations created by Occupational Safety & Health Administration (OSHA) or local governing
body.
 Inspection Method/Cycle
For the inspection method and cycle for the lockout/tagout mechanism, refer to the instruction
manual of the unit.

mycom 2016LMC Specifications

General

Brand	mycom
Model	2016LMC
Category	Air Compressor
Language	English