NAPCO Security Group
NAPCO Gemini C-Series Control Panel Programming Instructions--Volume 1
Page 8 Programming Instructions, Volume 1
operations in place of downloading (such as uploading the Fire log or the panel status, etc.). Later, if you still
wish to perform a download operation, Quickloader will again run another comparison and if there are differ-
ences, Quickloader will again warn of the mismatch with the dialog shown below.
Download Initiated Mismatch
The following dialog will appear when performing a download for both Telco and TCP/IP (Net.Link NL-MOD) connec-
tions and a mismatch is detected; this dialog is very similar to the dialog shown above (the Continue Despite Mis-
match button is replaced with a Cancel button, allowing the download operation to be exited without per-
forming any action):
In summary, for every download operation, Quickloader will attempt to check if the account and panel program are
identical. If a mismatch is found, Quickloader will warn of the mismatch with the dialog shown above.
Error-Check Overview
UL 864 requires that before a Fire Alarm control panel is placed into operation, the control panel programming must
be validated to ensure critical Fire-related programming parameters are set properly. The Gemini C-Series control
panels rely on the Quickloader Error Check utility to perform this required error check. Therefore, for all remote or
local download attempts, Quickloader will first error check the Quickloader account before the download process is
performed. If errors are found, the following dialog appears:
REMOTE DOWNLOADING RULES (CONT'D)
Note: This paragraph appears
only during remote download" at-
tempts; for local download attempts,
click No to continue with the down-
load ("ERROR CHECK REQ'D" will
appear on the on the Fire keypad).
To Next Page
Loading...
Need help?
General
