© National Instruments | 2-3
M Series User Manual
Cables and Accessories
NI offers a variety of products to use with M Series PCI, PCI Express, PXI, PXI Express, USB
devices, including cables, connector blocks, and other accessories, as follows:
• Shielded cables and cable assemblies, and unshielded ribbon cables and cable assemblies
• Screw terminal connector blocks, shielded and unshielded
• RTSI bus cables
• SCXI modules and accessories for isolating, amplifying, exciting, and multiplexing
signals; with SCXI you can condition and acquire up to 3,072 channels
• Low-channel-count signal conditioning modules, devices, and accessories, including
conditioning for strain gauges and RTDs, simultaneous sample and hold circuitry, and
relays
Refer to the appropriate section for your device connector type—
68-Pin M Series Cables and
Accessories
or 37-Pin M Series Cables and Accessories. For more specific information about
these products, refer to
ni.com.
Note For compliance with Electromagnetic Compatibility (EMC) requirements,
this product must be operated with shielded cables and accessories. If unshielded
cables or accessories are used, the EMC specifications are no longer guaranteed
unless all unshielded cables and/or accessories are installed in a shielded enclosure
with properly designed and shielded input/output ports.
Refer to the
68-Pin Custom Cabling and Connectivity or 37-Pin Custom Cabling section of this
chapter and the
Field Wiring Considerations section of Chapter 4, Analog Input, for information
about how to select accessories for your M Series device.
68-Pin M Series Cables and Accessories
This section describes some cable and accessory options for M Series devices with one or two
68-pin connectors. Refer to the following sections for descriptions of these cables and
accessories. Refer to
ni.com for other accessory options.
To Next Page
Loading...
Need help?
General
