4 | ni.com | NI Digital System Development Board User Manual
System Features
• 512 MB DDR3 with a 32-bit bus @ 1050 MHz
• 16 MB quad-SPI flash
• microSD socket for additional storage
• USB-JTAG programming circuitry
• Current and voltage monitoring on expansion connectors
• Powered from the NI ELVIS connector or 5 V barrel jack input
System Connectivity
• 16-bit VGA output
• Dual-role (source/sink) HDMI port
• NI ELVIS add-on connector
• 24-bit audio codec with headphone, line out, line in, and microphone jacks
• 10/100/1000 Mbps ethernet
• USB-UART bridge
Interaction and Sensory Devices
• 800 × 480 5-in. LCD display with capacitive touchscreen
• 128 × 32 monochrome OLED Display
• Four-digit 7-segment display
• USB HID connector for mice and keyboards
• Eight FPGA-connected LEDs
• One processor-connected LED
• Four push buttons
• Eight slide switches
Expansion Connectors
• MXP Connector
• Breadboard with analog I/O from NI ELVIS and digital I/O from Zynq
• Two Pmod connectors with eight FPGA I/O each
• One Pmod connector with eight Processor I/O
The DSDB is compatible with Xilinx’s new high-performance Vivado Design Suite as well as
the ISE/EDK toolset. These toolsets meld FPGA logic design with embedded ARM software
development into an easy to use, intuitive design flow. They can be used for designing systems
of any complexity, from a complete operating system running multiple server applications in
tandem, down to a simple bare-metal program that controls some LEDs.
To Next Page
Loading...
Need help?
General