User and Service Manual XLTEK EEG32U Amplifier
31
Unpacking
When you unpack the EEG32U amplifier, make sure the following items are included:
• EEG32U amplifier
• USB 2.0 cable
• Patient event switch
Optional Accessories:
• EEG accessory kit
NOTE: The EEG32U amplifier should be used only with cables, transducers, electrodes, sensor, and switches that are supplied or
approved by XLTEK.
Setting Up
NOTE: In the event of a power failure, the current recording will resume using the last programmed settings upon the
restoration of power.
The EEG32U amplifier is designed to work with an XLTEK computer system running XLTEK Database (XLDB) and NeuroWorks
software.
Placement of the Operator and Patient
It is expected that the operator of the system will stand or sit in front of the computer, but not continuously. The patient is
typically lying in a bed located beside the system cart or amplifier and is in no way supported by the equipment.
At no point should the system be leaned against or rested upon. Refer to the Transport System Specifications and Maintenance
section for placement, details, and cautions for the different cart transportation options.
Refer to the corresponding Instructions for Use for all system components prior to use. This should include, but is not limited to
cameras, computers, stimulators, and software.
Beginning a study
Once the equipment has been installed by the Natus qualified representative and a patient has been connected to the EEG32U
amplifier system, a new EEG study can be started. For details on beginning a new EEG study, consult the NeuroWorks manual
directly.
Powering Down the System
Follow these steps to ensure your system is powered down completely and safely.
1. Close any active studies in the NeuroWorks software.
2. Shut the computer down; ensuring to follow the proper shut down procedure.
3. Unplug the USB cable from the EEG32U amplifier.
To Next Page
Loading...
Need help?
General
