EasyManuals Logo
Home>NEC>Monitor>MultiSync P435

NEC MultiSync P435 User Manual

NEC MultiSync P435
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
English−33
Power ON and OFF Modes
Press the button on the Control Panel or POWER ON button on the remote control to turn on the monitor.
The monitor’s power LED indicates the current status of the monitor. Please refer to the following table for information about the
power indicator.
Power indicator status and
lighting pattern
Condition Recovery
Glowing blue Normal 1. Turn on the monitor by the remote
control or the monitor button.
2. Send an AV signal input to the
monitor.
Blinking green*
1
Under any of the conditions below, no input signal has
been detected by the monitor during the period of time
you set:
The monitor is using an Option Board*
2
.
[AUTO INPUT CHANGE] is set to a setting except for
[NONE].
[USB POWER] is set to [ON].
[SLOT POWER] is set to [ON].
[POWER CONTROL LINK] of [CEC] is set to [ENABLE].
[DisplayPort VERSION] is set to [1.2 MST] or [1.4 MST].
[QUICK START] is [ENABLE].
Glowing amber No AV signal input has been detected by the monitor during
the period of time you set. (with network signal input)
Blinking amber No AV signal input has been detected by the monitor during
the period of time you set. (no network signal input)
Glowing red Turn off the monitor by the remote control or the monitor
button.
Turn on the monitor by the remote
control or the monitor button.
*
1
: Time setting for auto power save is available at [POWER SAVE SETTINGS] (See page 100).
*
2
: [SLOT POWER] is [ON] or [AUTO].
NOTE: The blue power indicator that the monitor is powered on and functioning normally can be turned off in the monitor’s
OSD menu options. See page 105.
If the indicator is blinking red in a combination of long and short durations, a certain failure might have occurred.
Please contact your supplier.
The Main Power switch must be in the ON position in order to power up the monitor using the POWER ON button on the remote
control or the button on the Control Panel.
Main Power Switch
OFF
ON
Button

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC MultiSync P435 and is the answer not in the manual?

NEC MultiSync P435 Specifications

General IconGeneral
BrandNEC
ModelMultiSync P435
CategoryMonitor
LanguageEnglish

Related product manuals