16
Preset operation
The appliance switches on automatically, then switches off
automatically at the time preselected for the end of operation.
To set this function, combine the cooking time and end of
operation clock functions.
Bear in mind that food which spoils easily should not be left in
the cooking compartment for too long.
1. Set the operating mode and temperature.
2. Press the KJ clock function button repeatedly until the KJ
and
x symbols light up.
3. Set the cooking time with the rotary selector
(e.g.
‚:„‹ hours).
The setting is applied automatically.
4. Press the KJ clock function button repeatedly until the KJ
and
y symbols light up.
5. Set the end of operation using the rotary selector
(e.g.
‚ƒ:„‹ o'clock).
6. Press the ƒ Start button.
The appliance switches off and waits until the appropriate
time to switch on (
‚‚:‹‹ in the example). The appliance
switches off automatically at the time set for the end of
operation (
‚ƒ:„‹ ). A signal sounds and the y symbol
flashes.
7. Turn the operating mode selector to the Û position and push
it in.
Setting the clock
You can only change the clock when no other clock function is
active.
1. Press the KJ clock function button repeatedly until
the
KJand 3 symbols light up.
2. Set the clock using the rotary selector.
The setting is applied automatically.
Rapid heat up
Depending on the appliance features, you can reduce the
preheat time for the
3 Hot air and ë Bread-baking operating
modes if the set temperature is higher than 100 °C.
Note: During Rapid heat up, do not place any food in the
cooking compartment until the f symbol goes out.
1. Set the operating mode and temperature.
2. Press the KJ clock function button repeatedly until the KJ
and
f symbols light up and Πis displayed in the clock
display.
3. Turn the rotary selector clockwise.
Ž is displayed in the clock display and the f symbol lights
up. Rapid heat up is activated.
4. Press the ƒ Start button.
The appliance heats up.
After reaching the set temperature, Rapid heat up switches off.
The f symbol goes out.
Checking, correcting or deleting settings
1. To check your settings, press the KJ clock function button
repeatedly until the corresponding symbol lights up.
2. If necessary, you can correct your setting using the rotary
selector.
3. If you wish to cancel your setting, turn the rotary selector anti-
clockwise to the original value.
Childproof lock
In this section, you can read about
■ how to lock your appliance
■ how to lock your appliance permanently
Lock
Once it has been locked, the appliance cannot be switched on
accidentally or by unauthorised users (e.g. by children playing).
To switch the appliance on again, you must unlock it. After
appliance operation, the appliance is not automatically locked.
Lock it again if necessary or activate the permanent lock.
Locking the appliance
1. Switch on the appliance.
2. Press and hold the ± info button until™‚‹ (Appliance
unlocked) appears.
3. Turn the temperature selector until ™‚‚ (Appliance locked)
appears.
4. Press and hold the ± info button until the‚ symbol appears.
Note: If you try to switch the locked appliance on, -
†-
(Appliance locked) appears.
Unlocking the appliance
1. Press and hold the ± info button until™‚‚ (Appliance locked)
appears.
2. Turn the temperature selector until ™‚‹ (Appliance
unlocked) appears.
3. Press and hold the ± info button until the ‚ symbol goes
out.
To Next Page
Loading...
Need help?
General
