The Switch Information page displays.
5.
Select System > Maintenance > Access Control.
6.
For a device or range of devices that must be able to access the switch, configure
the following settings:
•
Source IP Address. Enter the IP address of the device or range of devices that
must be allowed to access the switch over a web browser.
•
Mask. Enter the subnet mask that is associated with the IP address.
7.
Click the Add button.
The device or range of devices is added to the table and your settings are saved.
Access control is now enabled.
8.
Repeat Step 6 and Step 7 for each device or range of devices that you want to add
to the Access Control table.
Remove Devices From the Access Control Table
You can remove a device from the Access Control table. If you remove all devices from
the table, access control is disabled.
To remove devices from the Access Control table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 10.
The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
User Manual59Manage and Monitor the Switch
Gigabit Ethernet Smart Managed Plus Switches
To Next Page
Loading...
Need help?
General