The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5.
Select System > Monitoring > Port Statistics.
The previous figure is an example. Your switch might provide more or fewer ports.
6.
To clear the port statistics, click the Clear Counters button.
All statistics counters change to 0.
PoE Considerations for Switches That
Support PoE
A switch that supports Power over Ethernet (PoE) prioritizes the PoE power that it supplies
in ascending port order (that is, from the lowest-numbered port to the highest-numbered
port), up to its total power budget. If the power requirements for the attached powered
devices (PDs) exceed the total power budget of the switch, the PD on the
highest-numbered port is disabled to make sure that the PDs that are connected to the
higher-priority, lower numbered ports are supported first.
Just because a PD is listed as an 802.3at PoE powered device does not necessarily mean
that it requires the maximum power limit of the specification. Many PDs require less
power, allowing all PoE ports to be active simultaneously.
The following table describes the PoE classes and switch allocations.
User Manual63Manage and Monitor the Switch
Gigabit Ethernet Smart Managed Plus Switches
To Next Page
Loading...
Need help?
General