Advanced Settings
110
N300 Wireless Router WNR2000v4
IPv6 6to4 Tunnel
To set up an IPv6 Internet connection by using a 6to4 tunnel:
1. Select Advanced >
Advanced Setup > IPv6.
The IPv6 screen displays.
2. Select 6to4 T
unnel from the menu.
The screen adjusts:
The information in the following fields is automatically detected by the router:
• Router
’s IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the router’s WAN (or Internet) interface. The number after the slash (/) is the length
of the prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
• Router
’s IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the router’s LAN interface. The number after the slash (/) is the length of the prefix,
which is also indicated by the underline (_) under the IPv6 address. If no address is
acquired, the field displays Not Available.
3. Configure the remote 6to4 relay router settings by selecting one of the following radio
buttons:
• Auto.
Your router uses any remote relay router that is available on the Internet.
This is the default setting.
• Static IP
Address. Enter the static IPv4 address of the remote relay router.
This address is usually provided by your IPv6 ISP.
To Next Page
Loading...
Need help?
General
