ACCESSORY CARD AXC 40
This accessory is used to enable connection and control
of shunt controlled additional heat, step controlled addition-
al heat, external circulation pump or ground water pump.
Part no. 067 060
ACTIVE/PASSIVE COOLING HPAC 40
The accessory HPAC 40 is a climate exchange module
that is to be included in a system with F1155.
Part no. 067 076
ACTIVE/PASSIVE COOLING IN 4-PIPE SYSTEM
ACS 45
Part no 067 195
AUXILIARY RELAY HR 10
Auxiliary relay HR 10 is used to control external 1 to 3
phase loads such as oil burners, immersion heaters and
pumps.
Part no 067 309
BASE EXTENSION EF 45
This accessory is used to create a larger connection area
under F1155.
Part no. 067 152
BUFFER VESSEL UKV
UKV is an accumulator tank that is suitable for connection
to a heat pump or another external heat source, and can
have several different applications. It can also be used
during external control of the heating system.
UKV 100
Part no. 088 207
UKV 40
Part no. 088 470
UKV 300
Part no. 080 301
UKV 200
Part no. 080 300
UKV 500
Part no. 080 114
COMMUNICATION MODULE FOR SOLAR
ELECTRICITY EME 20
EME 20 is used to enable communication and control
between inverters for solar cells from NIBE and F1155.
Part no. 057 188
COMMUNICATIONS MODULE MODBUS 40
MODBUS 40 enables F1155 to be controlled and mon-
itored using a DUC (computer sub-centre) in the building.
Communication is then performed using MODBUS-RTU.
Part no 067 144
COMMUNICATIONS MODULE SMS 40
When there is no internet connection, you can use the
accessory SMS 40 to control F1155 via SMS.
Part no 067 073
ENERGY MEASUREMENT KIT EMK 300
This accessory is installed externally and used to measure
the amount of energy that is supplied for the pool, hot
water, heating and cooling in the building.
Cu pipe Ø22.
Part no. 067 314
EXHAUST AIR MODULE NIBE FLM
NIBE FLM is an exhaust air module designed to combine
recovery of mechanical exhaust air with ground source
heating.
Bracket BAU 40
Part no. 067 666
NIBE FLM
Part no. 067 011
65Chapter 11 | AccessoriesNIBE F1155
11 Accessories