11
G
...
Man
4.5) Operation in “Manual with recorder” mode Man
1. Press key ■ repeatedly a number of times until Auto starts flashing
2. Press key twice until Man starts flashing
▼
3. Press key to confirm the “manual” mode with recorder
▼
... Auto
From this moment you can use PLANOTIME as if it were in “manual” mode, except that all the commands transmitted
using key or , together with the day, hour and minute on which they were transmitted, will be memorized as events.
Note: the “manual with recorder” mode does not enable the recording of events containing the “■” command.
▼
▼
A tip for the inexperienced: This operating mode is used to memorize events without having to program them
one by one. To record events that normally take place in the course of an entire week, access the “manual with
recorder” mode at the beginning of the week, then use PLANOTIME to command the daily up and down movement
of the automations every day at the desired time. At the beginning of the following week, set PLANOTIME to the “auto-
matic” mode; at this point the events will be repeated automatically through all the following weeks.
To delete an event recorded by mistake, see chapter 5.2.3.
Table 17 Selecting another group Example
1. Press key repeatedly in order to select the desired group
▼
2. Now you can use keys ■ to send commands to the selected group
▼
▼
Table 18 Assembling a multiple group and sending a command Example
1.
Starting from the 1st group, press key repeatedly in order to select another
group
▼
2. Press key to confirm the group
▼
...
3. Repeat the two previous steps to select other groups
4. When the multiple group has been assembled, you can use the following keys
■
to send the commands
▼
▼
Note: if you select and confirm the wrong group, you can delete it by repeatedly pressing key until the group to be
eliminated starts flashing, then press key .
▼
▼
Table 19 Sending a special command to a group or multiple group Example
1.
Starting from the 1st group, press key repeatedly in order to select another
group
▼
2. Press key to confirm the group
▼
...
... or
3. Repeat the two previous steps if you wish to select other groups
5. Press key to confirm the special command
▼
6. Now you can use the following keys ■ to send the special command
▼
▼
4. Press key repeatedly until the special command symbol “ ” or “ ”
starts flashing
▼
Table 20 Abandoning the “manual” mode and returning to the selection menu: Example
After sending a command, press key
▼
Or:
Make sure that no group has been selected then press one of the following
keys: ■
(if necessary, select the groups by pressing key and deselect / select
them by pressing key )
▼
▼
▼
▼
Or:
Press key ■ repeatedly a number of times until Auto starts flashing
... Auto
Table 21 Selecting the “manual with recorder” mode Example
To Next Page
Loading...
Need help?
General
