To Next Page

To Previous Page

2.3.1) Memorizing PLANOTIME as the first transmitter

When the code memory of the automation does not yet contain any codes, you can enter PLANOTIME following the

procedure described below:

Table 6 Memorizing PLANOTIME as the first transmitter Example

1. On PLANOTIME, select the group in which you wish to memorize the

automation, using the manual mode (Table 2)

2. Power the automation, you will immediately hear 2 long beeps **

3. Within 5 seconds, press and hold down key ■ on PLANOTIME

(for approx. 3 seconds)

4. Release key ■ when you hear the first of the 3 beeps confirming the

memorization

Table 5 Abandoning the “manual” mode: Example

After sending a command, press key

▼

Or: Press key ■ repeatedly a number of times until Auto starts flashing

Or:

Make sure that no group has been selected then press one of the following

keys: ■

(if necessary, select the groups by pressing key and deselect / select

them by pressing key )

▼

Warning: the code can be memorized in all the receivers found within the range of PLANOTIME; you should

therefore keep within range only the one involved in this operation.

All the memorization sequences are timed, which means that they must be executed within the set time limits.

** If the memory of the automation already contains codes, when the unit is powered you will hear 2 short beeps; in

this case you must follow the instructions provided in the table below.

2.3.2) Memorizing PLANOTIME as an additional transmitter

If the code memory of the automation already contains other transmitter codes, you can enter PLANOTIME follow-

ing the procedure described below.

Table 7 Memorizing PLANOTIME as an additional transmitter Example

1. On PLANOTIME, select the group in which you wish to memorize the

automation, using the manual mode (Table 2)

2. Press and hold down key ■ on PLANOTIME until you hear a beep coming form

the automation (after approx. 5 seconds)

3. Press key ■ on a previously memorized and operational transmitter 3 times

slowly

4. Press key ■ on PLANOTIME once more

Finally, 3 beeps coming from the automation will confirm that PLANOTIME has been correctly memorized.

If the code memory is full (14 codes), 6 beeps will warn you that PLANOTIME cannot be memorized.

... Auto

Nice planotime User Manual

Questions and Answers: