E8
Reference Section
Using 3D Photography
The camera takes one picture for each eye to simulate a three-dimensional image
on a 3D-compatible TV or monitor.
1 Frame the subject.
• The focus area that the camera focuses on can be
moved to areas other than the center of the frame.
To move the focus area, press the k button
before taking the first picture, and then rotate the
multi selector or press H, I, J, or K.
To adjust the following settings, press the k
button to temporarily cancel focus area selection,
and then adjust each setting.
– Focus mode (A (Autofocus) or p (macro close-up))
– Exposure compensation
2 Press the shutter-release button to take the first picture.
• The focus, exposure and white balance are locked after the first shot,
and R is displayed on the monitor.
3 Move the camera horizontally to the right
until the translucent guide is aligned with
the subject.
• To cancel shooting, press the k button.
4 Wait for the camera to automatically release the shutter.
• The camera automatically takes the second picture when it detects that the subject is
aligned with the guide.
• Shooting is canceled if the subject is not aligned with the guide within 10 seconds.
Rotate the mode dial to y M d button M s 3D photography
6030
To Next Page
Loading...
Need help?
General
Weight and Dimensions
