Safety Precautions
6
! CAUTION
1. Assembly of the microscope
• Assemble the microscope while the AC adapter is not connected to it.
• Take care to avoid pinching your fingers and hands.
2. Do not wet the product or allow ingress of foreign matter.
Do not allow the product to become wet, as doing so may result in malfunction, overheating, or
electric shock.
If water or other liquids are accidentally spilled onto the product, immediately unplug the power
cord from the AC adapter. Then, wipe off the liquid with a dry cloth.
Ingress of foreign matter may also result in malfunction. If liquids or foreign matter gets in the
product, cease use of the product, and contact your nearest Nikon representative.
3. Moving the product
• The microscope has carrying handholds and
handles.
There are two handholds on both sides of the
base and two handles on the arm on the rear side
of the microscope.
When carrying the microscope, hold the
microscope firmly by these handholds and
handles.
• The storage part on the rear of the microscope is
not a handle. Do not hold this part as it stores the
AC adapter and power cord.
• When moving the product, do not hold by the
focus knobs, eyepiece tube, and stage, etc. The
parts may become detached and also result in
malfunctions.
Hold a handle and a handhold. Hold the handles.
4. Disposal of the microscope
To avoid biohazard risks, dispose of the microscope as contaminated equipment, according to the
standard procedures for your facility.
Handhold
(both sides)
Handles
To Next Page
Loading...
Need help?
General
