Self-Timer
0
eration
You can use the self-timer when you want to be
in
the photograph. Use
a tripod
or
place the camera on a stable surface before using the self-
timer.
1
2
Press
~
(self-timer) button and confirm that
~
appears
on
the LCD panel.
Ili
:z
o
t;
:z
ir
~
• When
<::>
button is pressed, duration
of
camera's meter changes to 30 sec.
~
Press the shutter release button within 30 sec. of pressing the
<::>
button.
:z
• The self-timer cannot be performed unless the camera's shutter can be 0
released (i.e. when subject cannot be
in
focus with autofocus).
~
• To shoot
in
an
exposure mode other than Manual, cover the eyepiece with ~
the supplied eyepiece cap (page
56)
or hand before pressing the shutter 0
release button to prevent interference to achieve correct exposure from
~
stray light. <
• Do not stand
in
front
of
the lens when setting the self-timer
in
autofocus
to;
mode.
CI
Compose picture, focus and fully depress the shutter
release button .
• When the self-timer
is
activated, the shutter will release
in
10 seconds.
The self-timer/red-eye reduction lamp and
<::>
in
the LCD panel blink for 8
sec. and then stop blinking for 2 sec. before the shutter is released. When
Red-Eye Reduction (page
59)
is
set, the self-timer/red-eye reduction lamp
lights for 2 sec. before the shutter
re
leases at the same output level
as
the
normal Red-Eye Reduction function.
• To cancel the self-timer (before or during self-timer operation), press
<::>
button again, turn the main switch off or perform Two-Button Reset (page
57).
The self-timer can also be canceled by leaving the camera untouched
for
more than 30 sec. after setting the function.
55
To Next Page
Loading...
Need help?
General
