CONFIDENTIAL
Service & Analysis Center Europe
Training Team
version 1.0 / 19.10.1999 Page 18 of 41
Note! Rewrite SIMLOCK and IMEI entries with use of the Nokia security SW (SSSW) and make a SW-update or
send this phones to the SACE, if this procedure is not permitted to you
Contact service – ppm validity
Contact Service
Check via WINTESLA / Testing / Selftest
which kind of selftest is faulty
PPM validity fail
try to flash the phone
phone is Ok, if
CONTACT
SERVICE dissapears
after flashing
check soldering or
change D210,
FLASH
Yes
oK
not oK
SW / D210 Flash faulty / poor soldering
• Check if the fault disappear after update the handset
• Resolder D210 Flash
• Internal error of Flash