28
Settings
Tap the gear icon in the top-right corner of the touchscreen to open the Engine Lighting settings.
General
• Engine Lighting Status: This setting displays the current connection status to Engine Lighting devices. When
Running is shown, Engine Lighting is active. Tap Stop to deactivate Engine Lighting. Tap Start to reactivate.
• Connection Status: These indicators will show whether Engine Lighting is receiving signal from up to four
connected players.
• Sync Offset: Use this slider to apply a time offset for syncing your connected lights, from -1 to 0 to +1 seconds.
• Show Advanced Controls: Enable this option to toggle between the Basic and Pro controls.
• Randomize Autoloops: This setting determines whether autoloops are randomized or play in order.
• Override Scripted Tracks: This setting determines whether a scripted track that is paired with an audio file is
used (Off) or whether you can override it using the onboard controls (On).
• Loop Auto Strobe: This setting allows you to automatically generate strobe effects when a Loop Roll is engaged.
• Broadcast Art-Net: This setting allows you to enable or disable sending Art-Net protocol to control DMX
interfaces over a network connection.
• Strobes: This setting determines whether strobe effects are enabled or disabled.
• Philips Hue: Enable this option to connect to available Philips Hue smart devices.
• Fader Mode: This setting determines whether the light show changes continuously when both the crossfader
and channel faders are moved (Blend) or only by the position of the channel faders (Upfader Only).
• Active Faders: This setting allows you to enable or disable Engine Lighting control on up to four channels at a
time. Tap the CH1–CH4 names to activate each channel.
DMX Interfaces
Use this screen to view connected DMX interfaces and their Universe Assignments.
Philips Hue
Use this screen to set up Philips Hue devices.
To Next Page
Loading...
Need help?
General
