6.
7.
Slide the switch with the rails (A) and ears (C) installed on it into the left and right rails (B)
on the rack. Use four M6 screws (E) to fix the rack mount ears (C) to the rack. Do not tighten
the screws yet.
Sliding the Blades in the Rails
When fully inserted, fix the switch by tightening the 8 screws (E) inserted in Step 5 and Step
6 with a torque of 4.5±0.5.
At least two people are required to safely mount the system in the rack.
To Next Page
Loading...
Need help?
General
