1.
2.
3.
4.
5.
•
•
•
•
•
•
•
•
•
•
Removing the System from the Rack
To remove a unit from the rack:
Turn off the system and disconnect it from peripherals and from the electrical outlet.
While your installation partner is supporting the system’s weight:
Loosen the screws attaching the rack mount ears (C) to the rack. Do not remove them yet.
Loosen the screws attaching the rack mount blades (B) to the rack, and pull the blades
towards you, while your partner is holding the system.
Extract the loosened screws from Step 2 and dismount the system from the rack.
Remove the rails and brackets from the chassis by unscrewing 4 screws.
SN4600/SN4600C Telescopic Rail Kit
There are two installation kit options:
Standard depth systems should be mounted using the standard rail kit.
Short depth systems can be mounted using either of the rail kits.
Kit OPN Legacy OPN Rack Size and Rack Depth Range
930-9BRKT-00JJ-000 MTEF-KIT-F 600-800 mm
The following parts are included in the rail kit package (see figure below):
1x Right side slider (A)
1x Left side slider (B)
2x Rear rail (C)
2x Front rail (D)
10x M6 Standard cage nuts¹ ² (E)
10x M6 Standard pan-head Phillips screws¹ (F)
2x Phillips100 DEG F.H TYPE-I ST.ST 6-32 X 1/4 screw with around patch (G)
6x Flat head 100 DEG Phillips 4-40X3/16" ST.ST patch screws (H)
¹ Other threads are available by special order: M5, 10-32, 12-24
² G-type cage-nut is available by special order.
This document is preliminary and subject to change.
The telescopic rail kit is not included in the system’s package, and can be purchased
separately.
To Next Page
Loading...
Need help?
General
