Replacing consumable items> 103
T
ONER
CARTRIDGE
REPLACEMENT
The toner used in this printer is a very fine dry powder. It is
contained in four cartridges: one each for cyan, magenta, yellow
and black.
Have a sheet of paper handy so that you have somewhere to
place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly by placing it inside the
pack that the new one came in. Follow any regulations,
recommendations, etc., which may be in force concerning waste
recycling.
If you do spill any toner powder, lightly brush it off. If this is not
enough, use a cool, damp cloth to remove any residue. Do not
use hot water, and never use solvents of any kind. They will make
stains permanent.
Before changing the toner cartridge, switch off the printer and
allow the fuser to cool for about 10 minutes before opening the
cover.
CAUTION!
To avoid toner wastage and possible toner sensor
errors, do not change the- toner cartridge(s) until
“TONER EMPTY” is displayed through the Status
Monitor.
WARNING!
If you inhale any toner or get it in your eyes, drink a
little water or bathe your eyes liberally in cold water.
Seek medical attention immediately.
To Next Page
Loading...
Need help?
General
