EDITING FUNCTIONS
- 96 -
Outside Erase
You can whiten a shadow-like dark part which has appeared
outside of the copied image; this has been caused by a gap
between the document glass and the platen sheet. This
function is called “outside erase”. It is useful when you place
thick originals such as booklets on the document glass.
• This function is disabled when you place originals on the
RADF or you place them on the document glass with the
RADF or the Original Cover closed fully.
• When this function is enabled, the automatic density
adjustment is disabled. Adjust the density level manually.
• Originals with an intricate outer shape (e.g. an original with
cut-out parts on its edge) may not be copied properly
because this function may not detect the border between
the original and areas not belonging to it.
1
Place paper in the tray(s).
When using bypass copying, be sure to set the paper
size.
2
Select the tray for the desired paper size.
3
Press [OUTSIDE ERASE] on the EDIT menu.
4
Set “outside erase”.
1) Press [ON].
2) Adjust the width of the border around the original
by pressing either or as required.
When you adjust it to the side, the area to be
detected as not belonging to the original is widened.
When you adjust it to the side, the area to be
detected as not belonging to the original is narrowed.
3) Press [OK].
5
Place the original on the document glass.
Press [ZOOM] and set the size of the original.
Basic Guide
Note
• When placing the original, be sure that the Original
Cover or the RADF is fully raised. If not, this function
may not properly be able to detect the border between
the original and areas not belonging to it.
• Do not directly look at the document glass during
copying since an intense light may leak.
Do not place any heavy objects (4 kg (9 lb.) or over)
on the document glass and do not press on it with
force.
Breaking the glass could injure you.
6
Select other copy modes as required, and
then press the [START] button on the
control panel.
To Next Page
Loading...
Need help?
General
