Troubleshooting> 78
C
ANNOT
PRINT
WITH
LPR
AND
FTP
Turn the printer off for 15 seconds and then on again.
Check there is a response to the ping command.
Check the network cable is correctly connected.
Change the cable and try again.
Check the host name and IP address are configured in the
workstation.
Check the printer port name is configured in the workstation.
There are three port names: lp, euc and sjis. Use lp by default as
euc and sjis are specific to PostScript printers.
I
NCORRECT
USER
NAME
ON
THE
BANNER
PAGE
If printing with lpr, the user name printed is unknown and the
filename printed is the Spool file name.
If printing with FTP, the user name printed is the user name
entered during FTP login and the file name printed is the
transmitted file name. If the print directory name is indicated in
the put command, the file name is not printed. The printer name
printed is the logical directory name.
N
ET
BEUI
T
HE
NETWORK
INTERFACE
CARD
IS
NOT
IDENTIFIED
.
Turn the printer off for 15 seconds and then on again.
Check the network cable is correctly connected.
Change the cable and try again.
Check Microsoft Network Client and NetBEUI have been added to
the network section of the Windows Control Panel.
Check the NetBEUI protocol is set to Enable.
Check the factory setting of the workgroup name is PrintServer
and the computer name is ML+ the last six characters of the MAC
address.
Check the computer name of the NIC is different from the
computer name on the network.
To Next Page
Loading...
Need help?
General
