4
Recording menu [Rec Menu]
58
EN
Recording menu [Rec Menu]
Voice sync recording function
[V-Sync. Rec]
The voice sync recording function
automatically starts recording when a sound
louder than a preset voice sync recording
level (detection level) is detected, and
automatically stops recording when the
sound volume level decreases. When copying
music from another device connected to the
voice recorder, use the voice sync recording
function to detect the silent intervals
between music tracks and save each track as
a separate file.
[1 sec.], [2 sec.], [3 sec.], [5 sec.]:
Set the detection time. The voice
recorder enters standby mode when
the input (recording level) is below the
preset level for at least the set detection
time.
[Off]:
Recording is done normally.
Adjusting the voice sync level for voice sync
recording
1
Press the
REC
( s) button to
prepare for recording.
TIP
• Increasing the setting number
increases the VCVA activation
sensitivity, enabling quieter sounds to
activate the start of recording.
• Adjust the VCVA voice activation level
to suit the recording conditions (to
cope with high levels of surrounding
noise or the like).
• To avoid recording mistake, it’s
recommended to perform a test
recording beforehand to adjust the
voice activation level.
• To change the recording level
(☞ P. 54) during VCVA recording in
[Manual], press the F1 button. The
voice recorder changes to recording
level adjustment mode. Press the
F1 button again to return to voice
activation level adjustment mode.
NOTE
• The following function is disabled
when using the [VCVA] function:
• [V-Sync. Rec]
• [With recording] (☞ P. 71)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
