Olympus EVIS EXERA III User Manual

42
4.2 Inspection workflow
CLV-190 INSTRUCTION MANUAL
Ch.4
Follow each step of the workflow for inspection of the light source before use.
4.2 Inspection workflow
1
Check the lamp ignition mode.
Section 4.3 on page 43
2
Connect an endoscope.
Section 4.4 on page 43
3
Confirm that the light source is turned ON normally.
Section 4.5 on page 46
4
Check the total accumulated operating hours of the examination
lamp.
Section 4.6 on page 48
5
Confirm that the examination lamp turns ON/OFF normally.
Section 4.7 on page 48
6
Check the brightness mode.
Section 4.8 on page 50
7
Inspect the necessary functions (dependent upon the
endoscope).
• Brightness levelSection 4.9 on page 51
• Optical-digital observationSection 4.10 on page 56
• TransilluminationSection 4.11 on page 58
• High intensity modeSection 4.12 on page 59
• Air and water feedSection 4.13 on page 62
8
After inspection
Turn the examination lamp OFF if the light source will not be
used immediately.
Section 4.14 on page 64

Olympus EVIS EXERA III Specifications

General

Model	EVIS EXERA III
Category	Medical Equipment
Type	Endoscopy System
Manufacturer	Olympus
System Type	Video Endoscopy System
Video Processor	CV-190
HD Output	Yes
Power Requirements	100-240 V AC, 50/60 Hz
Image Quality	HDTV
Compatible Endoscopes	EVIS EXERA III series endoscopes
Image Enhancement	NBI (Narrow Band Imaging)
Light Source	Xenon Lamp