85
EN
Important information about
water and shock resistant
features
Water resistance: The waterproof feature is warranted
*1
to operate at depths up to 15 m (49.2 feet) for up to one
hour.
The waterproof feature may be compromised if the
camera is subject to substantial or excessive impact.
Shock resistance: The anti-shock feature warrants
*2
the operation of the camera against accidental impact
incurred from everyday use of your digital compact
camera. The anti-shock feature does not unconditionally
warrant all defective operation or cosmetic damage.
Cosmetic damage, such as scratches and dents, are not
covered under the warranty.
As with any electronic device, proper care and
maintenance are required to preserve the integrity
and operation of your camera. To maintain camera
performance, please take your camera to the nearest
Olympus Authorized Service Center to have it inspected
after any major impact. In the event the camera is
damaged as a result of negligence or misuse, the
warranty will not cover costs associated with the service
or repair of your camera. For additional information on
our warranty, please visit to the Olympus website for your
local area.
Please observe the following care instructions for your
camera.
*1 As determined by Olympus pressure testing
equipment in accordance with IEC Standard
Publication 529 IPX8 - This means that the camera
can be used normally under water at a speci ed
water pressure.
*2 This anti-shock performance is con rmed by
Olympus’ testing conditions in accordance with
MIL-STD-810F, Method 516.5, Procedure IV
(Transit Drop Test). For more details of Olympus’
testing conditions, please refer to the Olympus
website for your local area.
Before Use:
• Check the camera for foreign material including dirt,
dust or sand.
• Firmly close the battery/card cover lock, connector cover
lock and LOCK knob.
• Do not open the battery/card cover and connector cover
with wet hands, while under water, or in a damp or dusty
environment (e.g. beach).
After Use:
• Be sure to wipe off any excess water or debris after using
the camera under water.
• After the camera is used under seawater, immerse
the camera in a bucket containing fresh water for
about 10 minutes (with the battery/card cover and
connector cover rmly closed, the lock in place and
the lens ring removed). After that, let the camera dry
in a shaded location with good ventilation.
• When opening the battery/card cover or connector
cover, open slowly with the camera orientated as
shown in the following illustration to prevent water
drops entering the camera. If any water drops are
found on the inner side of the cover, be sure to wipe
them off before using the camera.
Battery/card cover
To Next Page
Loading...
Need help?
General
