Omron E2E series User Manual

6
．
Communications Settings
8
6. Communications Settings
This section describes the contents of parameter and device variable settings that are all
defined in this document.
6.1. EtherCAT Connection Parameter
The parameter required for connecting Controller and Slave Terminal via EtherCAT is shown
below.
<Slave Terminal Setting>
Item
Set value
Remarks
Node address 1
Set the address using the hardware switches on Slave
Terminal.
6.2. IO-Link Connection Parameter
The parameter required for connecting IO-Link Master Unit and Proximity Sensor via IO-Link
is shown below.
In this document, Proximity Sensor is connected to Port 1 on IO-Link Master Unit.
<IO-Link Master Unit Setting>
Item name
Value
Port1 IO-Link Device Configuration Data / Master Control
IO-Link Mode (Default)
6.3. Slave Terminal Configuration and Device Names
The Slave Terminal configuration and device names are shown below.
The default values are used for the device names. For slave units, the default device names
are "E" followed by a serial number that starts from 001.
For NX Units, the default device names are N followed by a serial number that starts from 1.
<Slave Terminal configuration and device names>
NX Unit number
Name
Model
Device name
0
EtherCAT Coupler Unit
NX-ECC202
E001
1
IO-Link Master Unit
NX-ILM400
N1
0
1

Omron E2E series Specifications

General

Brand	Omron
Model	E2E series
Category	Network Hardware
Language	English