8
Initialization method
8. Initialization method
The setting procedures in this document are based on the factory default settings.
Some settings may not be applicable unless you use the devices with the factory default
settings.
8.1. Initializing Controller
To initialize the Controller settings, it is necessary to initialize CPU Unit.
Change the operating mode of Controller to PROGRAM mode and select Clear All Memory
from the Controller Menu in Sysmac Studio. The Clear All Memory Dialog Box is displayed.
Check the contents and click OK.
8.2. Initializing Salve Terminal
To initialize the Slave Terminal settings, connect Slave Terminal directly to Personal computer
on which Sysmac Studio runs.
(1) Connect the USB cable to the peripheral USB port on EtherCAT Coupler unit.
USB cable
To Next Page
Loading...
Need help?
General
