Omron E5CZ Manual

36 Digital Position-Proportional Controllers E5EZ-PRR
Operation
In the past, sensor input types, alarm types, and control time for controllers were set using the DIP switch. Now, these hardware settings can
be performed with the parameters in the setting level. The and M keys are used to switch between setting levels, with the level determined
by the amount of time the key is pressed. Two examples of typical setup procedures follow.
• Typical Examples
Changes in Set Values
• Typical Example 1
L
intl
onof
in-t
0
M
M
M
in-h
100
in-l
0
intl
onof
25
c
0
Changes in Data
l.ini
l.ini
l.ini
l.ini
l.ini
0 100.
When there are multi
parameters, press down
on the mode key until all
necessary parameters
have been selected.
Changes can be
made to data on
displays with the
UD key.
25
c
0
M
alt1
2
in-t
5
M
al-1
c
20
20
100
25
c
100
M
M
M
r-5
run
Setup Steps
Initial setting level
Operation level
Connect the
power supply
Connect the power supply
Set the input
type
Set the
alarm type
Set the
alarm value
Begin operations
Be
g
in o
p
erations
Alarm value 1
While running
Process value/ set value/
percentage of valve opening
While stopped stop
Check alarm type
Check input type
5
Input type
1
Alarm
2
Alarm
Operation level
Operation level
Initial setting level
Control starts
Control stops
L
L
l.ini
l.ini
l.ini
l.ini
run
100. .0
100. .0
C
Input Type : 5K thermocouple -200˚C to 1300˚C
Control Method : PID Control
Alarm 1 Type : Upper limit of 2 (deviation)
Alarm Value 1 : 20˚ C (deviation)
Set value : 100˚ C
Press the key for at
least 3 seconds
Press the key for at
least 1 second
Press the DU
key, and designate
the set value as
100
˚ C
Press the DU
key, and set the
alarm value as
20
˚ C
Confirm that
control is
operating
Process value/ set
value/percentage of
valve opening

Omron E5CZ Specifications

General

Brand	Omron
Model	E5CZ
Category	Temperature Controller
Language	English