Omron E5EN User Manual

CHAPTER 4 APPLIED OPERATION
4-1
CHAPTER 4
APPLIED OPERATION
CHAPTER4
4.1 Shifting Input Values 4Ć2...................
Shifting input 4Ć2.........................
How to calculate input shift values
(2Ćpoint shift) 4Ć3..........................
1Ćpoint shift method 4Ć4....................
2Ćpoint shift method 4Ć4....................
Example of 2Ćpoint temperature
input shift 4Ć5.............................
4.2 Alarm Hysteresis 4Ć6......................
Standby sequence 4Ć6......................
Alarm latch 4Ć6............................
Close in alarm/open in alarm 4Ć7............
4.3 Setting Scaling Upper and Lower Limits
(analog input) 4Ć8.........................
Analog input 4Ć8..........................
4.4 Executing Heating and Cooling Control 4Ć10..
Heating and cooling control 4Ć10.............
Setup 4Ć11.................................
4.5 To Use Event Input 4Ć12....................
Setting event input 4Ć12.....................
How to use multiĆSP 4Ć12...................
Setting by key operation 4Ć13................
Setup 4Ć13.................................
Executing run/stop control 4Ć14..............
4.6 Setting the SP Upper and
Lower Limit Values 4Ć15.....................
Set point limitter 4Ć15.......................
Setup 4Ć16.................................
4.7 Executing the SP Ramp Function
(limiting the SP change rate) 4Ć17............
SP ramp 4Ć17..............................
4.8 To Move to the Advanced Function
Setting Level 4Ć19..........................
4.9 Using the Key Protect Level 4Ć20.............
Key protect 4Ć20............................

Omron E5EN Specifications

General

Brand	Omron
Model	E5EN
Category	Controller
Language	English