12
Overview of System Startup Procedure Section 2-1
• NS indicator: Lit green.
2-1-5 Common Operating Procedures
This section provides the procedures that are used to set up and start an Eth-
erNet/IP Unit.
Common Procedure 1. Configuration Used in Common Procedures
Common Procedure 2. Starting the Network Configurator
Common Procedure 3. Installing EDS Files
Common Procedure 4. Connecting the Network Online
Common Procedure 5. Uploading the Current Network Configuration
Common Procedure 6. Setting IP Addresses
Common Procedure 6-1. Setting IP Addresses for OMRON EtherNet/IP
Units
Common Procedure 6-2. Setting IP Addresses Using the Network Config-
urator
Common Procedure 6-3. Setting IP Addresses Using the BOOTP Server
Common Procedure 6-3-1. Enabling BOOTP from the Network Con-
figurator
Common Procedure 6-3-2. Setting IP Addresses Using the BOOTP
Server
Common Procedure 7. Setting Tag Data Links
Common Procedure 7-1. Setting the I/O Sizes of Devices
Common Procedure 7-2. Registering Tag Sets in the PLC
Common Procedure 7-2-1. Setting Tag Sets Using Physical Address-
es
Common Procedure 7-2-2. Setting a Tag Using a Symbol
Common Procedure 7-2-3. Combining Tags Into a Single Tag Set
Common Procedure 7-3.Setting Connections
Common Procedure 7-4.Downloading Connection Settings to Devices
Common Procedure 7-4-1. Downloading the Same Connection Set-
tings to All of the Devices in the Network
Configurator
Common Procedure 7-4-2. Downloading Connection Settings to Se-
lected Devices
Common Procedure 1. Configuration Used in Common Procedures
The following figure shows the configuration and IP addresses used in the
common procedures.
The subnet mask is set to 255.255.255.0 and the same network address is
set for all devices.
Personal
computer
(192.168.0.100)
EtherNet/IP device
(192.168.0.20)
OMRON
EtherNet/IP Unit
(192.168.0.10)
HUB
Ethernet
cable
Ethernet
cable
Ethernet
cable
To Next Page
Loading...
Need help?
General
