Omron NX102 series Network Connection Guide

7．IO-Link Connection Procedure
12
7.2. Slave Terminal Setup
Set up the Slave Terminal.
Hardware Settings
Build the Slave Terminal, set hardware switches and connect the Signal Tower.
Precautions for Correct Use
Make sure the power supplies are OFF before setting up.
If either of them is ON, the settings described in the following steps and subsequent
procedures may not be applicable.
1
Make sure Unit power supply
and I/O power supply are OFF.
2
Connect IO-Link Master Unit to
EtherCAT Coupler Unit.
3
Check the position of the
hardware switches on EtherCAT
Coupler Unit by referring to the
figure on the right.
4
Set Rotary switches and DIP
switch as follows:
・Rotary switches
x10: 0
x1: 1
・DIP switch
4 (ADR+100): OFF
*The node address is set to 1.
Rotary switches DIP switch
IO-Link Master Unit
End cover
EtherCAT Coupler Unit
Rotary switches
DIP switch

Omron NX102 series Specifications

General

Brand	Omron
Model	NX102 series
Category	Controller
Language	English