Version Upgrade Information
60
ZFX-C Serial Communication Command Reference
Version Upgrade Information
The following describes the content of the software version upgrade.
Ver1.00 to Ver1.10
Ver1.10 to Ver1.20
Ver1.20 to Ver1.30
Ver1.30 to Ver1.50
Changes
The following backup and restore commands can now be used in Ethernet communications, too:
BGRLOAD, BGRSAVE, BNKLOAD, BNKSAVE, SYSLOAD, SYSSAVE
Changes
The following image data backup/restore commands have been newly added:
IMGLOAD, IMGSAVE
Changes
"Angle" has been newly added to the edge inspection parameters of the MEASDATA command.
Changes
The following commands were added:
MEASPARA, POSIPARA, CLRMEAS, CLRERR, ERRHISTORY, CAPTURE
The new feature to re-measure the saved image has been added to the MEASURE command.
To Next Page
Loading...
Need help?
General
