FUEL SOLENOID
FIGURE 18. FUEL SOLENOID VALVE LOCATION
FUEL
SYSTEM
Engine fuel may not be primed at the fuel filters after
shipment. To verify and reprime the fuel system perform
the following procedure:
1.
Remove each fuel filter (Figure 19) and fill with clean
fuel.
2.
Put a light coat of fuel on the sealing gasket.
3. Install and tighten by hand until the gasket just
touches the filter head.
4.
Tighten the filter an additional one-half to three-
fourths of a
turn.
SUPPLY LINE,
FILTER TO
INJECTION PUMP
FUEL SUPPLY
NLET
VENTILATION
Verify all air vents and ducts are open and free of
any obstructions. Verify dampers, if used, operate
properly.
EXHAUST
SYSTEM
Check the exhaust system for proper installation.
Verify there is at least 12 inches (305 mm) clearance
between exhaust pipes and any combustible
materials.
ELECTRICAL
SYSTEM
Verify all electrical connections are secure and all
wiring is complete. Replace and secure any access
panels that may have been removed during install-
ation.
Battery
Connections
Use two 12-volt batteries for a normal installation.
Connect positive battery cable before connecting
negative battery cable to prevent arcing.
Service the battery as necessary. If an automatic
transfer is not used or is installed without a build-in
charge circuit, connect a separate trickle charger to
the battery.
Load
Connections
Check that load cables from generator set are prop-
erly connected to either a transfer switch or circuit
breaker panel.
MECHANICAL
CHECK
Check the generator set for loose or damaged com-
ponents and repair or replace as required.
FUEL FILTERS
FIGURE 19. FUEL FILTERS
17
To Next Page
Loading...
Need help?
General
