Advanced Settings
36
Direct
Make the settings for Pure Audio and Direct listening modes.
Setting Item Default Value Setting Details
Analog Subwoofer Off Set the output of low-frequency signals from the
subwoofer during playback in Pure Audio or Direct
listening mode.
"Off": No output
"On": Output
r
The setting cannot be changed if "Speaker
Configuration" - "Subwoofer" is set to "No".
DSD DAC Direct Off Set processing of DSD (Super Audio CD) audio
signals performed by DSP when Pure Audio or
Direct listening mode is selected.
"Off": DSD signals are processed by the DSP.
"On": DSD signals are not processed by the DSP.
4.Source Setup
Adjust the volume level difference among the multiple devices connected to this unit,
rename an input selector, or adjust the image quality. The setting can be separately set to
each input selector button. When you select a desired input to check the video or audio,
start playback of the connected device.
AccuEQ Room Calibration
Setting Item Default Value Setting Details
AccuEQ Room
Calibration
Off Enable/disable the sound field set in automatic
speaker setup
"On": Enable this function
"Off": Disable this function
r
This setting cannot be changed in any of the
following cases.
– Automatic speaker setup is not performed.
– Headphones are connected.
IntelliVolume
Setting Item Default Value Setting Details
IntelliVolume 0 dB Adjust the volume level difference between the
devices connected to the unit. Select a value
between "-12 dB" to "+12 dB".
Set a negative value (–) if the volume of the target
device is larger than the others and a positive
value (+) if smaller.
r
To Next Page
Loading...
Need help?
General
