Advanced Settings
41
6.Miscellaneous
Volume Setup
Make the detailed volume setting of the unit.
Setting Item Default Value Setting Details
Volume Display Absolute Switch the volume display between the
absolute value and relative value. The absolute
value 82 is equivalent to the relative value 0dB.
"Absolute": Absolute value such as "0.5" to
"99.5"
"Relative (THX)": Relative value such as
"-81.5dB" and "+18.0dB"
r
If the absolute value is set to "82.0",
"82.0Ref" will appear on the display and the
"THX" indicator will flash.
Muting Level Set the volume lowered from the listening
volume when muting is on.
(in 10dB increments)
Maximum Volume Off Set the maximum value to avoid too high
volume. Select a value from "Off", "50" to "99".
Power On Volume Last Set the volume level of when the power is
turned on. Select a value from "Last" (Volume
level before entering standby mode), "Min", "1"
to "99" and "Max".
r
You cannot set a higher value than that of
"Maximum Volume".
Headphone Level 0 dB Adjust the volume level difference between
speakers and headphones. Select a value
between "-12 dB" to "+12 dB".
OSD Setup
Make the setting of on-screen display function that can display the setting menu screen,
volume operation screen and the like on the TV.
Setting Item Default Value Setting Details
On Screen Display On Set whether or not to display the On Screen
Display (OSD) on the TV.
"On": The operation screen will be displayed on
the TV.
"Off": The operation screen will not be displayed
on the TV.
r
The operation screen may not be displayed
depending on the input signal even if "On"
is selected. If the operation screen is not
displayed, change the resolution of the
connected device.
Language English Select the OSD language.
Screen Saver 3min Set the time to start the OSD screen saver.
Select a value from "3min", "5min", "10min" and
"Off".
12V Trigger A Setup
You can enable power link operation when you connect the unit and the external devices
equipped with 12V trigger input jack. When the desired input is selected, power link
operation will be activated with a control signal of maximum 12V/150mA output from the
12V trigger output jack.
Setting Item Default Value Setting Details
Delay 0sec Set after how many seconds the 12V trigger
output will occur in response to the unit's
operation. As some devices cause a large
current when they turn on, delay the output if
such devices are connected. Select a value
between "0sec" to "3sec".
To Next Page
Loading...
Need help?
General
