Orban 5750 Technical Manual Specifications 7-15
Audio-Over-IP I/O (AoIP)
Standard:
- With Dante Module: Fully supports Dante networks. SMPTE ST2110-30 RTP AES67 compliant
- With AES67 Module: AES67 SMPTE ST-2110-30/31, NMOS4, NMOS5 and seamless switching ST2022-7,
RAVENNA compliant
Number of Input Channels Supported: Two (2) stereo pairs.
Number of Output Channels Supported: Four (4) stereo pairs.
Sample Rate: 44.1, 48, 88.2 and 96 kHz.
Networking: Two RJ45 Ethernet connectors for connection to dedicated audio-over-IP LANs (supports DANTE
redundancy if Dante module is used). These connections are independent of the Optimod’s main Remote
Computer Interface and have their own IP and MAC addresses. These are automatically assigned and can be
discovered in Dante Controller (Dante Module) or JSON API, NMOS IS-05, ANEMAN & Web UI (AES67 Module)
Composite Baseband Outputs
Configuration: Two outputs, each with an independent software-controlled output level control, output amplifier
and connector.
Source Impedance: 0Ω voltage source or 75Ω, jumper-selectable.
Load Impedance: 37Ω or greater. Termination not required or recommended.
Maximum Output Level: +16.0 dBu (13.82Vp-p).
Pilot Level: Adjustable from 6.0% to 12.0%, software controlled.
Pilot Stability: 19 kHz, ±1.0 Hz (10 degrees to 40 degrees C).
D/A Conversion: 24-bit
Signal-to-Noise Ratio: >= 85 dB (Bypass mode, de-emphasized, 20 Hz – 15 kHz band- width, referenced to 100%
modulation, unweighted).
Distortion: <= 0.05% THD (Bypass mode, de-emphasized, 20 Hz – 15 kHz bandwidth, referenced to 100%
modulation, unweighted).
Stereo Separation: At 100% modulation = 3.5Vp-p, >60 dB, 30 Hz – 15 kHz. At 100% modulation = 1.0 - 8.0 Vp-p,
>55 dB.
To Next Page
Loading...
Need help?
General
