REMOTE
The OFF/ON button cannot be used.
LOCAL
All wired remote control buttons can be used.
Time/time setting display
Check display
Fan speed display
Operation mode selection display
FILTER RESET display
(Appears after the cumulative running time reaches
approximately 2,500 hours of operation.)
Temperature setting display (16°C - 31°C)
Airflow direction setting display
OFF/ON button
Used to start and stop the operation.
FAN SPEED button
Used to select the fan speed of high (HI), medium (MED), low
(LO) or auto (AUTO).
MODE button
Used to select the operation of AUTO, HEAT, FAN, COOL, or
DRY.
TEMP (UP/DOWN) buttons
Used to select the desired temperature.
AIR SWING (AUTO/MANUAL) buttons
Used to determined the air swing condition, either auto or
manual.
FILTER RESET button
Press to reset the “FILTER RESET” display after washing the
filter.
TEST RUN button*
VENTILATION button*
ECONOMY operation button
Provides Energy saving function
ODOUR WASH button
Provides deodorizing function.
CHECK button
Press this button if the check display is flashing.
TIMER/CLOCK SET buttons
Used to set the timer operation and the current time.
Operation indicator
Lights up when the unit in operation.
8 WIRED REMOTE CONTROL OPERATING INSTRUCTIONS
8.1. Name and function of each part
NOTES
•
Ensure that the correct button is pressed as simultaneous pressing of the multiple buttons will not make the setting correct.
•
The illustration above is for explanatory purposes only. The appearance will be different during actual operation.
•
Do not operate the remote control with wet hands. Otherwise, electric shock or malfunction may occur.
•
Do not press the remote control buttons with sharp object as this may damage the remote control.
•
Buttons marked with * are not needed for normal operation. If one of these buttons is pressed by mistake, press the same
button once more to cancel the operation.
•
When the power resumed after power failure, the unit will restart automatically with all the previous settings preserved by
the memory function. (Auto restart function)
•
Buttons marked with
are not available for operation. If one of these buttons is pressed function will not be available.
26
To Next Page
Loading...
Need help?
General
