69
Recording mode
Taking pictures after automatically setting the
aperture value and shutter speed
(Programme AE Mode)
Recording mode:
Take pictures using automatic aperture values and shutter speed settings in accordance
with the brightness of a subject.
1
Set mode dial to [ ]
2
Press the shutter button halfway
• If the aperture value and shutter speed flash red, you do not have the correct
exposure.
3
While the numeric values are displayed
(approximately 10 seconds), rotate the
rear or front dial to change the values
using Programme Shift
Programme Shift indication
Aperture value
Shutter speed
8.05.64.0
250 125 60 30 15
• It will switch between Programme Shift operation and Exposure Compensation
operation (→112) every time the rear dial is pressed while the values are
displayed (only when [Exposure Dial] (→49) is set to [OFF]).
• To cancel Programme Shift, either turn off the camera or rotate the rear or front
dial until the Programme Shift indication turns off.
• Programme Shift can easily be cancelled by setting a function button to [One
Push AE]. (→60, 75)
About Programme Shift
The function for maintaining the same exposure (brightness) while changing the
aperture value and shutter speed combination is called “Programme Shift”. You can use
“Programme Shift” to take pictures by adjusting the aperture value and shutter speed
even in Programme AE Mode.
●
Programme Shift cannot be used in the following cases:
• When recording using the flash
• When recording 4K photos
• When recording using [Post Focus]
• When ISO sensitivity is set to [
]
To Next Page
Loading...
Need help?
General
