193
SQW0740
Using Menu Functions
Menu list
→ [Custom]
[Histogram]
Enabling/disabling the histogram display.
When set to [ON], you can move the display position of the histogram by pressing .
• Direct touch operation is also possible from the recording screen.
Displays distribution of brightness in picture – e.g.
if the graph peaks at the right, this means there are
several bright areas in the picture. A peak in the centre
represents correct brightness (correct exposure). This
can be used as a reference for exposure correction, etc.
(Example)
Dark ← OK → Bright
●
When the histogram is not the same as that of the recorded picture under the following
conditions, histogram will be displayed in orange:
• During Exposure Compensation
• When the flash fires.
• When the correct exposure is not achieved, such as when the lighting is low.
[Guide Line]
Sets the pattern of the guidelines to be displayed while recording.
●
When you select [ ], you can move the position of the guideline by pressing .
●
You can also set the position directly by touching [ ] on the guideline of the recording screen.
●
The guideline is not displayed during panorama picture recording.
[Center Marker]
A cross [+] is displayed to indicate the centre of the recording screen. This is useful for
zooming while keeping the subject at the centre of the screen.
To Next Page
Loading...
Need help?
General
