Panasonic Lumix DMC-TS2 User Manual

- 89 -
Advanced (Recording pictures)
∫ About focusing
When [CONTINUOUS AF] (P122) is set to [ON], and you focus on a subject, the camera
will maintain focus on that subject. To fix the focus position when beginning to record a
motion picture, set to [OFF].
Note
•
The screen will change as follows when the motion picture button is pressed in steps 2 and 3.
¢1 Press [DISPLAY] to display the available recording time before recording motion pictures.
¢2 The screen that is displayed during Motion Picture Mode setting is different depending on the
setting of the
[REC MODE].
Start recording by pressing the motion
picture button.
A Available recording time
B Elapsed recording time
• Release the motion picture button right after you press
it.
• The audio is also recorded simultaneously from the
built-in microphone on this unit. (Motion pictures
cannot be recorded without audio.)
• The recording state indicator (red) C will flash while
recording motion pictures.
• The screen will become dark momentarily, and
recording will start after adjusting the display.
Stop the recording by pressing the motion picture button again.
• Sound will go off when pressing the motion picture button indicating start/stop of Motion
Picture Recording.
Sound volume can be set in [BEEP LEVEL] (P36).
• If the built-in memory or the card becomes full in the middle of recording, the camera
stops recording automatically.
A Still Picture Recording
screen
¢1
B Motion Picture Mode
setting
¢2
C Motion Picture
Recording screen
D Still picture Mode
setting
B
A
C
R1m21sR1m21s
R1m21s

3 s 3 s

Panasonic Lumix DMC-TS2 Specifications

General

Brand	Panasonic
Model	Lumix DMC-TS2
Category	Digital Camera
Language	English