15
Power ON / OFF
Connecting the plug to the Wall Outlet.
Note:
When disconnecting the AC cord, be absolutely sure to
disconnect the AC cord plug at the socket outlet fi rst.
Press the Power switch on the Plasma Display to turn the
set on: Power-On.
Power Indicator: Green
[Starting up the network]
It takes some time for the network to start up just after the
power is turned on.
During that time, “NETWORK SETUP” in the “SETUP”
menu is grayed out and cannot be set.
Press the button on the remote control to turn the Plasma Display off.
Power Indicator: Red (standby)
Press the button on the remote control to turn the Plasma Display on.
Power Indicator: Green
Turn the power to the Plasma Display off by pressing the switch on the unit,
when the Plasma Display is on or in standby mode.
Note:
During operation of the power management function, the power indicator turns
orange in the power off state.
Connecting the AC cord plug to the Plasma Display.
INPUT MENU ENTER/
+
/VOL
-
/
Power Indicator
Remote Control Sensor
To Next Page
Loading...
Need help?
General