USER MANUAL
R E M O T E C O N T R O L
ENABLING/DISABLING AN IMMOBILIZER RADIO TAG
Write down or remember the «Service PIN-code»
To enable/disable a radio tag, enter level 15 (the system should be in programming
mode). Enter the «Secret PIN-code» to disable radio tag or press VALET button once
to enable radio tag.
Enter the «Service PIN-code» to enter the programming mode (factory preset of
the «Service PIN-code» is «1-1-1-1»). You can enter the code only if the base unit is
powered, the ignition is switched off, the system is disarmed and the maintenance
mode is switched off. If there is no «Service PIN-code», you can enter programming
mode using the «Secret PIN-code» written on the owner’s card. After entering
programming mode, press VALET button 15 times. Green color of LED indicator
means a radio tag is switched on, red color means a radio tag is switched off.
Disabling a radio tag:
LED indicator will light green after entering the programming level. The system will
wait for entering the «Secret PIN-code». Enter the «Secret PIN-code» that is written on
the owner’s plastic card. The system will confirm disabling of the radio tag with two
sound signals of the siren and a long red LED flash. After that the system will return to
the programming menu. If the PIN-code is not entered within 10 seconds or the input
is incorrect, a siren will sound one signal, LED will produce the series of red and green
flashes and the system will return to the programming menu.
WARNING! It is highly recommended to change factory preset of the
«Service PIN-code» for improving security of the system.
To Next Page
Loading...
Need help?
General
