PANDORA LIGHT PRO SERVICESECURITY SYSTEM
R E M O T E C O N T R O L
When changing settings are done, the values should be saved. To do this, proceed
to Send settings sublevel by pressing of button and press button to save
new settings. Changes will be sent to the base unit, it will be confirmed with double
sound signal of the remote.
To exit menu, press and hold button for 1 second.
NOTE: If you have not saved new settings, remote and automatic engine start settings will
remain the same as before.
NOTE: Engine start via temperature is available only if temperature sensor is connected. The
sensor availability depends on the system set.
WARNING! Enable remote start if your local legislations allows driverless
cars to have working engine.
AUTOMATIC ENGINE START
The system allows setting up modes of automatic engine start and stop.
Synchronized real-time clock on the remote and base unit and other autonomous
system settings allow many engine start options without needing to have the remote
in command radio range.
Automatic start and engine work conditions programming is done using LCD
remote. Shortly press button to enter «REMOTE START SETTINGS» menu.
Shortly press button to switch between menu sublevels. Sub-level values are
changed using and buttons.
To Next Page
Loading...
Need help?
General
