USER MANUAL
ARMING/DISARMING IN HANDS FREE MODE
The system allows for programmable Hands Free arming and disarming. To arm the
system, when the ignition is switched off, move with the remote tag away from the
car at a distance greater than the regular radio coverage (10 meters for 2,4 GHz) –
the system will be armed automatically. To disarm the system, move toward the car
with remote tag. Enabling/disabling this function can be performed with Pandora
AlarmStudio software.
ARMING/DISARMING IN SLAVE MODE
In this mode it is possible to monitor the status of original security system of the car
via CAN-bus or by analog inputs. When arming and disarming original security system,
Pandora will be armed and disarmed respectively. The presence of a tag in the radio
zone is not required, but at the beginning of motion if the tag is not detected by the
system, the engine will be blocked.
There is an option in the system settings named «Prohibit disarming when the tag
is absent». When this option is enabled, disarming procedure will be performed only if
there is a tag in the radio zone.
IMMOBILIZER MODE
This mode is disabled by default. Use Pandora AlarmStudio to enable this mode.
When switching on the ignition, the base unit of Pandora security system performs
a search for immobilizer tags in radio zone. If no radio tags were detected when the
ignition is switched on, the system will block the engine with all radio relays that were
programmed into the system. Engine blocking will only occur when motion sensor
detects movement of the car. If additional analogue blocking relays were installed,
they will block the engine immediately, before or when the car starts moving, it
depends on system settings.
I M M O B I L I Z E R
To Next Page
Loading...
Need help?
General
