3
Network
3.1
Connect to Network
Wireless Connection
What You Need
To connect the TV to the Internet wirelessly, you need a Wi-Fi
router with a connection to the Internet.
Use a high-speed (broadband) connection to the Internet.
Make the Connection
Wireless
To make a wireless connection…
1 - Press
and press
(left)
Setup
.
2 - Click
Network
and click
Connect to Network
.
3 - Click
Wireless
.
4 - In the list of found networks, click on your wireless network.
If your network is not in the list because the network name is
hidden (you switched off the SSID broadcast of the router),
select
Enter Name
to enter the network name yourself.
5 - Depending on the type of router, enter your encryption key
- WEP, WPA or WPA2. If you entered the encryption key for
this network before, you can click
OK
to make the connection
immediately.
6 - A message will be shown when the connection is successful.
WPS
If your router has WPS, you can directly connect to the router
without scanning for networks. If you have devices in your
wireless network that use the WEP security encryption system,
you cannot use WPS.
1 - Press
HOME to open the Home menu.
2 - In the menu bar, click
Apps
and click
Setup
.
3 - Click
Network
and click
Connect to Network
.
4 - Click
WPS
.
5 - Go to the router, press the WPS button and return to the
TV within 2 minutes.
6 - Click
Connect
to make the connection.
7 - A message will be shown when the connection is successful.
WPS with PIN Code
If your router has WPS with a PIN code, you can directly
connect to the router without scanning for networks. If you have
devices in your wireless network that use the WEP security
encryption system, you cannot use WPS.
1 - Press
HOME to open the Home menu.
2 - In the menu bar, click
Apps
and click
Setup
.
3 - Go to
Network
and click
Connect to Network
.
4 - Click
WPS with PIN code
.
5 - Write down the 8-digit PIN code shown on screen and
enter it in the router software on your PC. Consult the router
manual on where to enter the PIN code in the router software.
6 - Click
Connect
to make the connection.
7 - A message will be shown when the connection is successful.
Problems
Wireless network not found or distorted
• Microwave ovens, DECT phones or other Wi-Fi 802.11b/g/n
devices in your proximity might disturb the wireless network.
• Make sure that the firewalls in your network allow access to
the TV's wireless connection.
• If the wireless network does not work properly in your home,
try the wired network installation.
Internet does not work
• If the connection to the router is OK, check the router
connection to the Internet.
The PC and Internet connection are slow
• Look in your wireless router's user manual for information on
indoor range, transfer rate and other factors of signal quality.
• Use a high-speed (broadband) Internet connection for your
router.
DHCP
• If the connection fails, you can check the DHCP (Dynamic
Host Configuration Protocol) setting of the router. DHCP
should be switched on.
Wired Connection
What You Need
To connect the TV to the Internet, you need a network router
with a connection to the Internet. Use a high-speed (broadband)
connection to the Internet.
8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
